NFC RFID modul med android extension

92.50 DKK incl. moms

Kun 2 tilbage på lager

Varenummer (SKU): E12-5 Kategori:

NFC is a popular technology in recent years.
Near field communication (NFC) is a set of standards for smart phones and similar devices to establish radio communication with each other by touching them together or bringing them into close proximity, usually no more than a few centimeters.
For electronics geeks, we also want to use NFC technology to make our own things.
This module is built around NXP PN532. NXP PN532 is very popular in NFC area.
We almost break out all the IO pins of the NXP532 chip on this module. Users could easily connect and play.
With the Arduino Sensor Shield, it is very easy to plug and play. However, if users want to use other interface such as UART or SPI, the module also support this.


  • Small dimension and easy to embed into your project. Support I2C, SPI and HSU (High Speed UART), easy to change between those modes.
  • Support RFID reading and writing, P2P communication with peers, NFC with Android phone.
  • RFID reader/writer supports: 1. Mifare 1k, 4k, Ultralight, and DesFire cards; 2. ISO/IEC 14443-4 cards such as CD97BX, CD light, Desfire, P5CN072 (SMX); 3. Innovision Jewel cards such as IRT5001 card; 4. FeliCa cards such as RCS_860 and RCS_854
  • Up to 5cm~7cm reading distance. Arduino compatible, plug in and play with our shield.
  • On-board level shifter, Standard 5V TTL for I2C and UART, 3.3V TTL SPI

Package included:
1 x PN532 NFC RFID Module
1 x 2.54mm spacing 4pin Cable
1 x Mifare One S50 White Card
1 x Mifare One S50 Key Card
1 x 12P bended male pins


Mere info

Læs mere om NFC RFID modulet i manualen – hvor der også er links til downloaf af nødvendige libraries.

Yderligere information

Vægt 25 g